Since I have installed the Ignitor the engine won’t start. What can I check?

The first step in troubleshooting is answering these questions:

• Is the kit correct for your application?
  

• Was the Ignitor installed without modification?
  

• Was it installed as instructed?
  

• Did the engine run before the Ignitor installation?
  

If you answered "NO" to any, resolve the issue before continuing. If "YES," check for these common no-start issues:

• Insufficient voltage to the Ignitor red wire.
  

• Excessive air gap between the module and magnet sleeve.
  

• Disconnected ground wire inside the distributor.
  

• Loose wire connections.
  

• Incorrect polarity.